Professional Glazing Machine Electric Drill Nail Art Manicure Pedicure

Specifications:
Main (power supply & control) part
Rated voltage range: 100-120V 60 Hz
Output rated voltage: DC 0-13V
Output current: 1.5A
Shell Material:Plastic

Handpiece (motor) part
Working voltage: DC 0-13V
Rated current: 1.5A
Rated speed: 0 -30000RPM
Material:Stainless Steel

Power supply size:5.31 x 5.12 x 3.31inch/13.5 x 13 x 8.4cm(L x W x H)
Handpiece size:5.39 x 1.06inch/13.7 x 2.7cm(L x Dia)
Sanding bands size: 0.24 x 0.31 x 0.51inch/0.6 x 0.8 x 1.3cm (Inner dia x Outer dia x L)
Foot pedal cable length:55.91inch/142cm
Power supply cable length:65inch/165cm
Cord of Handpiece length:29.53-63.0inch/75-160cm
Package Size:9.65 x 8.07 x 3.82inch/24.5 x 20.5 x 9.7cm

Package included:
1 x Main (power supply & control)
1 x Handpiece
6 x Metal Grinding Drill Bits
6 x Sanding bands
1 x Foot Pedal Power Control
1 x Purple Silicon Stand
1 x English Manual

Installation and wire connection:
Connect the 5-pin plug of the portable hand piece to the Output socket at the main panel.
Connect the pedal switch to the FOOT socket
Select proper drill bit according to actual requirements, and fasten it into the front of the portable grinding head.
Switch the speed control to the left(Min)
Connect with the main source power.

Operation:
1.Press the function switch to HAND for manual control,the indicator will be on and the grinding head starts to moving slowly.
2.Turn the SPEED CONTROL to the right to accelerate the grinding head
3.When the function switch is pressed to FOOT, step on the pedal and the machine starts to work (foot switch is optional)
The turning directions can be swapped. FWD means clockwise direction and REV means counterclockwise direction
Adjust the speed of the grinding head within a reasonable range
Please adjust the handpiece to lowest speed before changing forward/backward direction

Introductions:
Don't change the turning directions too frequently, otherwise, it will damage the grinding head.Turn the SPEED CONTROL counterclockwise to decelerate the grinding head the minimum before turning off and switch the main power source to 0.After operation, put the grinding head on the top of the main panel.While the grinding head is in operation, never pull out the 5-pin plug of the portable grinding head.For long idle time. please disconnect the source power. Any unauthorized disassembling of the product is prohibited.